Welcome to GreatFold - Making businesses better

washroom partitions

  • washroom partitions

washroom partitions




Before the installation of the toilet washroom partitions, understand the size of the partition to be installed, and perform the laying-out, and then fix the frame to prevent the partition from becoming unstable during the installation process. After all these are set, the door leaf can be installed.
Install the wall fixing piece:
Draw the center line of the fixing piece on the wall, see that there are several screw holes for fixing in the fixing class, and punch a corresponding number of holes along the center line on the wall, pre-bury the plastic plug in the hole, and expand it. Screws fix the fixing piece to the wall.
Fixed adjustment base:
According to the pre-designed installation drawing, find the position of the base on the bathroom floor and draw the center line, and then fix the base at a position about 20 cm away from the edge of the partition board.
Install the partition:
The installation position and height of the partition are determined by the wall fixing piece and the adjustment base. Therefore, the first two steps of the work must pave the way for the installation of the partition board. Place the partition on the wall fixing piece and the adjusting foot, and raise the partition to a position about 15 cm above the ground. Then use a level to measure whether it is level, and then use screws to fix the partition on the wall fixing piece and the adjustment foot.
Tie rod installation:
(1) Cut and fix according to the actual length of the compartment. When the straight rod is connected flatly, in order to ensure a smooth, beautiful and firm connection, a circular socket and a connecting spring sheet should be installed in the tube;
(2) For the 90-degree corner tie rod of the compartment, use a 90-degree corner joint to connect the tie rods on both sides of the corner;
(3) Fix the terminal rod on the wall with screws;
(4) Use screws to connect and fix the tie rod and the fixing piece on the upper edge of the column.
Fixed column:
Draw a vertical line to the ground on the wall, make sure it is perpendicular to the ground, and drill a hole on the line, and pre-bury the plastic plug sleeve in the hole. Use screws and an L-shaped fixing piece to fix the column at a height of 150 cm from the ground. On the wall.
Fix the upper edge tie rod fixing piece and the L-shaped edge connecting piece on the terminal post, and then fix it on the partition with screws.
Install the hinge on the upright first, and then install the hinge piece on the corresponding position on the door leaf. After installation, lightly lift the door leaf and fix the nylon seat in the hinge seat. Open and close the partition door and check to see if it can be opened to the required angle and can be closed normally.

Recommend Products