Philippines phenolic toilet partitions project

Location:Philippines

Application:Office building

Thickness:12mm

Height:3.3meter

Area: 214square meter

Material:HPL board + stainless steel hardware

Precautions for installation of phenolic toilet partitions
1. After laying floor tiles and wall tiles, make bathroom partition walls
When decorating the bathroom, the floor tiles and wall tiles should be laid first, and then the bathroom partition walls should be customized according to the actual required size. It should be noted that the sewer pipes and floor drains must be installed before the floor tiles are laid, and the possible errors on the upper and lower walls should also be considered. The problem is that it is easy to install and use the glass door according to the actual size.
2. Consider the water resistance of the door frame threshold
Consider whether the glass partition of the bathroom has a door frame to block water. If there is no special installation of threshold stone, the threshold stone should be generally 1.5cm-2cm higher than the ground, otherwise the shower water will flow out from under the door, and the purpose of dry and wet partition will not be achieved. It is easy to cause inconvenience, so you need to pay attention, do not use the slideway, because the water and dust in the slideway are difficult to clean, and it will stink for a long time.
3. A handle bar should be installed on the side of the bathtub
The bathtub in the bathroom is the place where the entire family needs to take a bath, and there are dangerous factors such as water and shower gel in the bathroom that may easily cause slipping. If there are elderly people and children at home, you need to pay more attention to this detail.
4. The glass door should choose organic or tempered glass
The glass door of the shower room should be made of plexiglass or tempered glass. If the glass is colorless, try to paste a pattern at a considerable eye level to avoid crashing the glass.