Key points of movable partition decoration

Movable partitions bring great convenience to people's work, such as movable screens. When needed, the partition wall can be folded on one side to connect the two spaces together, making it larger and convenient for temporary departmental meetings; such as movable partitions, generally our company’s factory buildings may be rented. For various reasons, we can’t help but Need to change place. The shortcomings of traditional partitions are now clearly highlighted, because you cannot take away the components of the house. On the contrary, movable partitions can be removed and reorganized, so movable partitions have a reputation for decoration that can be taken away! Then partitions should also pay attention to decoration considerations Bar.
　　 1. At the partition repair site, partition tools must be prepared, and the power supply and rack must be in place.
　　 2. The installation steps of the partition door panels on both sides of each partition are as follows: flip the partition door panels, align the notches, and leave a distance of 8 cm between the panels.
　　 Three. Pay attention to the following issues during maintenance, the facade is not flat / the partition is unstable.
　　 1. If the wall partition is uneven, you can adjust accordingly according to the finish. The surface of the partition can be measured with a spirit level, pay attention to leaving a gap of 10 mm.
　　 2. The distance between the partition doors should be consistent, and the horizontality of the side of the movable partition should be measured with a line. Glue should be used when repairing. After repairing, clean the surface of the partition.
Movable partition
　　Four, finalize the work
　　 1. Repair be careful not to damage the door panel
　　2. Install the card slot board, remember that the card slot board should not be installed too tightly, it is usually stuck
　　3. Install sound insulation cotton on the partition door, and then seal it.
　　4. After the partition door panel is installed, it can be used as a partition soft cover. The soft cover is made of fabric and leather.
　　5. After the partition is maintained, debug it. Try to see if it can be fixed up and down and moved left and right.